Robert Axle Project Resistance Trainer 12mm Thru Axle, Length: 174 or 180mm Thread: 1.75mm
- Details
- Send to friend
- Customers also bought
- Customer feedback
Robert Axle Project thru axles allow modern frames to be used with axle mount trainers.
- For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more
- IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using
- Measure trainer at the widest setting and measure the bike frame width at the rear hub
- The Robert Axle ends will extend 15mm past the frame on each side
- Axle shaft and axle ends are machined from 7075 aluminum and hard anodized
- Installed or removed using a 5mm Allen wrench
- Designed, built and tested in the USA
-
DT Swiss Black Spoke 2.0 206 Without Nipple$2.99
-
Jagwire Mountain Sport Brake Pads Threaded Post Black$7.99
-
Alligt 100mm Idler Pulley 8mm Hole$64.99
-
Sunlite Shifters ATB R&L 3x7 w/V-BRK Lever$29.99
-
Vittoria Corsa G2.0 Tire - 700x25, Clincher, TAN, 320tpi$86.99
-
Sunlite BB Axle Nut Flanged 14mm EACH$5.99
-
Shimano XT CS-M771 10-Speed 11t Cog for 11-34/36t Cassette Each$6.99
-
Sunlite 20x1.75 Freestyle - Kontact Tire$19.99
-
Sun Seeker Recumbent Basket$109.99